mattanna

Hi all, would 245/45 tyres fit an 18inch wheel which is 9.5 width or would it be too much of a stretch?

Huge thanks to Tony for doing geometry today and sorting tyres too, could not meet a nicer or more knowledgeable bloke, thanks again, 180 mile round trip well worth it! Matt

Hello mate, my car is going in Thursday for the tweaking and new rubber, get yours in!! :crying:

Great avatar where did you get that!!!

Hi all i have a Toyota Aristo v300 which is producing about 300bhp at the rear wheels.It has Tein hr coilovers fitted and the car is slightly lower than standard. It has 18 inch wheels with 235/40 tyres.I wanted to have alignment checked so took it for 4 wheel laser alignment, their computer only had settings for standard Lexus gs300(same car body and chassis wise) and told me that camber toe everything was out, and because it had aftermarket suspension they would not touch it. I had not thought about the suspension, so what i am asking is that is there any way of truly aligning a modified suspension setup?, the car has no handling problems other than spinning me 180 degrees on a dual carriage way slip road yeaterday due to greasy roads and 1st turbo coming in The garage that fitted the teins set it up probably with a bit of toe in for grip etc but all this is double dutch to me.I wanted to check alignment after my spin although i don't think this damaged it, what advice do you have. I presume comparing my car to a stock car on alignment computer is pointless?? cheers Matt