ExtremeFam07

Tony is the man he'll get it straightened out. I have yet to rebuild my caster arms yet as i had to put a clutch in my wife's car which ended up including both cv axels and all struts. So my car is next and I'll only get it aligned to your specs (Tony) remember for anyone else my car is lowered on H&R springs.

Only gold members can upload directly to the forum. You will need to upload the photo to a different host like dropbox, flickr etc and then embed it here Thank you. I would've been looking all over. Here are the current measurements. I know the caster is more than likely out due to worn LCA #2 bushings so the caster arms will be rebuilt with puly bushings before final alignment. Would i need another check after i rebuild them before final alignment? Here is my google drive folder with the current results. https://drive.google.com/folderview?id=0B9kIt2xYEDHoVFE5RWFjYTJpZFE Thank you.

Hello everyone, I need your help tony. My tires are being destroyed. First I know my caster is off as i need to replace the worn out caster bushings. I have planned on using these http://www.shopfigs.com/v1/index.php?route=product/product&path=42&product_id=87 However as reading from your post it seems as if the caster measurement is not good from factory so i wanted to know if you recommend me useing these instead http://www.shopfigs.com/v1/index.php?route=product/product&path=42&product_id=256 If so what position would need to be utilized to correct the factorys caster issue? My car is lowered on h&k springs so where should my other targets be for good tire wear? I have so many ququestions for you but not going to overload you with them all at once.😀 thank you Tony. I'm going to spread the word about this forum in the my.is forum as a lot of people need your help. As most accept this inner tire wear. 😖😕 I haven't seen a way to attach a picture on here to show the current geo. Is it due to the mobile layout?