Hi all . Recently I've fitted new wishbones , poly consoles , tie rods and ends , ball joints , top mounts (both parts) . And ap 25mm kit .. Went and had geometry checked yesterday, obviously was out, they adjusted the front toe , however when I was handed a printout,camber on passenger side was -1/2 degree and showing green on chart . But drivers side was -2 degrees and showing red ( out of spec )
Now I know you cannot adjust camber .. Is there anything I can do to try to even it out ?? And if I do try to sort it . Will it throw the toe out again ??
Regards Tony ..
Also when u questioned the guy who did it . He said it ain't that bad ..