vrba

thanks again Tony

hehe thx, i taught that again i have to give money for geometry

Hi, me again I have don geometry and car is now all good but now i need to change drop links cause i'm hawing some knocking over bumps . So my question is should i be doing geometry again after the drop links have change? In my logic drop links does not effect geometry. Am i right. (i hope that i am)

thx i know now pressure for next year when i put 235 for now i will go with 2.2 for all 4 as i pumped it today. mine is pre facelift think same as yours

only 2.0 BAR? by manual original 205/65 15 on 7J 15 should be on 2.2. would new size be less inflated than original cause i dont know how the things with pressure changing goes. does tis tinner and wider tyre should be less inflated?

what tyre pressure in BAR should i put in 225/45 17? i dont have this dimension in manual so i dont know what is the right pressure fot this tyre rims are 8J 17 car is Omega B 2.5 V6 '97 manual

thx Tony, you seem to answer my questions first and only. Car is not lowered so /40 will leave to much room, my question is in general what is better for driving and for car assuming that 235/45 is larger than 225/45 for apx. 1 cm. and by that wheel is almost the same size as original 205/65 15

is there an optimal tyre dimension for rims 8X17 ET35. Car is Omega b 2.5 v6 i am thinking of putting 235 45 17 and other solution is 225 45 17, original tyres were 205 65 15.

thx but they look little bit different than those on the picture, they are flat all over the edge and not V shaped and they are hard to push in (guess that is all right) is correct word for it spigot?

can you pleas explain tapered side and flush. cause i dont know what tapered means and what flush

i bought new set of rims and with them 4 center rings so i have 2 questions: 1. rings have one side round and the other flat, what side faces the rim when inserting and what side faces the disc? 2. does the ring must be pushed into the rim fully (to the end of the ring hole), or just to be aligned with the edge of the rim. sorry if this is not to well written cause it is hard to me to explain all the things that i was thinking at the moment in eng.

hi, i m driving omega b 2.5 v6 '97 manual and i'm planing to buy new rims so i'm wondering about that ET. current rims are original opel 7X15 ET 33 with 205/60 15 (original tires by manual are 205/65). those that i plan to buy are 8X18 ET42 i think and tires 235/40 18. anyone know can i put that ET and that size without any problem or what and dose anyone can say how the car goes with that size wheels

thx how did you do that?

thx

if only i could know where i can do this at craoatia. ufffffff what pain in the ass