-
Posts
89 -
Joined
-
Last visited
About RobPhoboS
Previous Fields
-
Vehicle
350z
Profile Information
-
Gender
Male
-
Location
Surrey & East London
RobPhoboS's Achievements
Newbie (1/14)
2
Reputation
-
Same thing happened to my sister, in the same car !
-
I've seen how quickly heat can transfer from a battery to a misplaced ratchet - it was scary ! Glowing red then starting to go white, could have been a mess like the above.
-
Yeah I thought with the camber I was quite lucky, maybe a tad too much on the rear but still not bad. I can only assume it's because the car is sitting slightly lower but I spent some time trying to get them close to the same height.
-
I thought I'd just get it quickly checked today to see where it is after fitting the GT1's:
-
I'm sure loads of you have seen this before but I hadn't, so thought I'd share as it popped up
-
http://www.youtube.com/watch?v=UIzOLNzytjM
-
Would you lease a car from this website?.....
RobPhoboS replied to Tony's topic in Car Related Photos/Videos
haha - look at the video tutorial on this page, brilliant: http://www.lingscars.com/car-leasing.php#models -
I love the design on that - although I *think* this is what it'll be, which is still good:
-
That's really great to hear ! I've been absolutely stunned at how good the customer service and communication has been, and of course the product itself so far on the road has done exactly what I wanted it to.
-
I shall be back again soon Sadly the Bilstein suspension is off, I found with the SPL metal bushings the ride became quite harsh and irritating. I found myself scanning the road constantly for drain covers, twigs, leaves and so on. It's simply due to the gassing they've chosen to pressurise their shocks with, meaning it takes more force to get them working, usually that's completely fine when you're on rubber bushings but not the metal ones. Great shocks but a bad combination I didn't consider. I'm now on Meister R GT1's (first in the UK on the Z), and these feel fantastic ! There were plenty of options to go for, KW V3 were going to be my decision but I opted out for a couple of reasons. The GT1's have hugely reduced the harshness, and now of course I can dial up or down the rebound/compression quickly and easily for track fun. I'll book a tweak again during February
-
My aussie flatmate is also capable of going full on nuclear He managed to clear a 10m square area in a packed Serbian nightclub, I was dying with laughter. As well as either perfect coincidental timing, back in London, outside a pub, he dropped then some guy made a screwed up face then threw up
-
Lotus Cup Europe - Crazy burning car......
RobPhoboS replied to Tony's topic in Car Related Photos/Videos
Eeeek - that's pretty scary ! I know Roger Green (Evo mag) had a serious fire like that during the N24 a few years back. -
Amazon Prime Clarkson Hammond May Show....
RobPhoboS replied to Tony's topic in Car Related Photos/Videos
That sounds pretty good to me, PM the address ! -
Bearing/Bush Drivers
RobPhoboS replied to Rich's topic in General Problems / Discussion (NOT Geometry Related)
Well only you can figure this out bud, I enjoy working on my car so prefer to do as much as I can, then go to a specialist when it's beyond me. -
Bearing/Bush Drivers
RobPhoboS replied to Rich's topic in General Problems / Discussion (NOT Geometry Related)
Change the selection to 55mm, for some reason the link keeps going to 50 ! Product Dimensions 15 x 7.2 x 7.2 cm In my case it was probably air that caused the problem, kms are really good to deal with and they said they'd replace it if leaking still.